shirsch
Veteran Member
I'm sure I'm doing something wrong, but not having any luck with this driver. The machine has the primary floppy (FlashFloppy Gotek) attached to a Promise 4030 IDE/floppy card and that's been working correctly. I installed an Adaptec 1542B adapter jumpered as secondary, where it is seen correctly by Imagedisk. I added this line to config.sys:
The system boots with no errors and reports the availability of the floppy at drive E (second hard drive partition is D). However when I try to access the drive from DOS, e.g. 'DIR E:' the system just hangs with no disk access or motor start occurring. Shouldn't this be working? The attached drive is a standard DSDD full-height drive that's jumpered as 'Drive 1' on the end of a twisted cable.device=c:\dosfdrv.sys /u:2 /d:0