Bitly's latest activity

They look like wire wound resistors, but I can't be certain. I wouldn't replace them unless they measure open circuit, or are physically...

The resistors have cooked the board, but the traces don't look damaged. C11 might be bulging slightly, and it's proximity to the...

That is likely the source of the SCSI-B error, and can be ignored. CW

E is time-of-year clock C is serial port 6 is SCSI-B 1 is ethernet (probably not terminated) I don't know if the SCSI-B failure is an...

Is there any documentation on these 'special' DEC parts besides the block diagrams that show up in various appendices? I've been...

I hadn't considered platter sag. I always assumed the on-edge storage was to fit more in a cabinet, but it make sense. Fortunately, they...

Sounds reasonable. It takes a pretty serious shock to damage an RL pack, I have not seen one go bad in my 30+ years due to shocks. Pack...

I'm preparing to move, and I need to box up ~25 RL02 cartridges. What is the best (correct?) way to package them? They aren't going to...

Depends on your patience and level of skill. It looks like most of the Cypress parts and at least two DIMM sockets will have to be...

Disclaimer: I know nothing about this subject. If memory serves, certain 11/23 CPUs contain boot ROMs that know how to control a DEQNA...

I can't find any documentation online for the LQP02 (schematics, etc). If you have hardcopies please scan them so they can be added to...

Both those options should work electrically. I didn't check the physical size. CW

Unfortunately, I've already put them away. I'm in the process of painting, so everything is piled under tarps. I did look at an older...

I looked at one of my 3100s, and I have the same board. On closer inspection, I believe the component is an old style tantalum capacitor...

Puzzling. The M38 should have a KA42 motherboard, but it doesn't match the component locations in the online documents. Perhaps it's a...