Recent content by Mike1978

Not sure if it’s of interest here but my t3100 came with a network card. I’ve yet to locate any details about how to use it or interface with it sadly this is the machine with the bad drive so I know a lot of the drive went bad I don’t believe I’ve seen any remnants of drivers for it and a web...

Hi I saw these first on Reddit then found a link to your site and of course now here. Would really like one of your cards for a t3100e and I have a t3200 but not sure if your card supports that model. Would be keen to get one of the cards in and running as the 20mb drive is full of bad sectors...

You need to set the lpt to 2 using a ref disk then use the sddrv.sys from the nc100sd folder I just copy it to the root of the c drive on mine. Hope that helps Mike

Quite the journey! Small steps but better to understand these things.

Amazing so pleased you got that card going :) watching progress, hoping you get your other card up and running

Fingers crossed great progress!

Hey Paul, so does that mean with the R8207-16’s you may be up and running? Impressive work so far :) Mike

I had wondered if these bodge wires may have at some stage come away for some of these cards.. they will have had an interesting life since the time they were made. This one crossed the pond at least once! Mike

Great find ! Here’s hoping

Great! Thanks for confirming

Hey @Chuck(G) It’s time for me to get one of those chips ordered then, so can you confirm it’s a straight bridge chip for u111 to swap to 8bit ? Eg: Pins have a connection between 1 to 14 2 to 13 3 to 12 etc… Assuming it’s straight across Thanks in advance! Mike

Thanks Saif I guess it will be a voyage of discovery. Looking at NC_Mike’s picture it looks to be a straight shunt across the pins. I did message Mike also to ask and the other posts confirm it. If you get to try this with your card do let me know I likewise will update when I try it as yet I...

I was tempted to try GLaBIOS but I don’t think it adds anything in terms of different fdd support.

I was hoping that was both parts and they could be ordered prebuilt. Still it’s a great progress.

Watching and hoping for some success for you :)