KLund1
Veteran Member
I have this card
and a IBM 5150 64-256Kb MB. The MB boots fine. I do get a 131 error, but I am using a modern PSU without -5v
I can not get the FD to boot.
I using known good Teac FD-55BR drives, and good cables, and disks
I have the MB switches set for a single drive for testing.
There are a lot of jumpers on the DTK FD card. I am unsure about what most of them do. I have it set for a 360Kb drives on JP3.
I reseated the DTK bios chip and cleaned the card edged.
The drives clicks at power up. The DTK board displays a boot message and the drive initializes. There is slight pause 1.5 seconds perhaps, then the system drops to BASIC.
The other jumpers currently set are
JP1 1,2 closed
JP2 1,2 closed
JP3 A,B,C,D closed
JP4 A, C closed
JP5 Closed
Could some of you smart people see what might be wrong?
Thanks
PII-151B IO card Settings and Configuration
PII-151B, IO card, memory, data bus, user configuration, chipset and other specs
stason.org
I can not get the FD to boot.
I using known good Teac FD-55BR drives, and good cables, and disks
I have the MB switches set for a single drive for testing.
There are a lot of jumpers on the DTK FD card. I am unsure about what most of them do. I have it set for a 360Kb drives on JP3.
I reseated the DTK bios chip and cleaned the card edged.
The drives clicks at power up. The DTK board displays a boot message and the drive initializes. There is slight pause 1.5 seconds perhaps, then the system drops to BASIC.
The other jumpers currently set are
JP1 1,2 closed
JP2 1,2 closed
JP3 A,B,C,D closed
JP4 A, C closed
JP5 Closed
Could some of you smart people see what might be wrong?
Thanks