Search results

Hi to all, Someone can help me? I have an excellent Tandy 1400LT computer with original boot disk. The computer boot perfectly and the screen is clear. Download from internet, Deskmate II and when run it the software load well, but the screen flicker. I don't know if the software is designed...

Hi, I have a brand new pens printer, make a setup install all pens and power on, As per manual the printer should be print 4 square color pattern. But just print a a 4 line pattern. and the when push the paper switch should be feed the paper, but just move a little the head and no feed paper...

I just got a brand new Commodore 8032, in original box. But I need any software in order to test it. I have a Datassette unit but not any software. Any help with this. Also I'm looking for dual drive 8050 with cable. Thanks

Hi friends, I have a Coleco Adam computer with 80k memory, Power on and start in Electronic type writer, but when type a letter appears in the screen but not print. Also change to Word processor mode and type some letter, the try to print but the printer do not respond. Any help with this...

I have this floppy drive that will be use in Model 100, 102 and 200, But I have not the serial cable to connect it, Anybody know to build this cable or where can I found? Thank you very much.

I have a new never opened Sinclair 1000, today was opened and tested, So I will run 2k cassette and work fine. But to run a 16K cassette I need a 16K module. Power off the computer and connected the 16k module, the power on and wait few minutes for the computer test the memory, but nothing...

Hi to all, Does anybody know how to check, how much memory have my computer? I have a model 4p with TRSDOS, LDOS, MultiDOS, and some other programs. In Basic mode when type Print Men jus appears 29974. I check the computer and appears to have 128k, due all socket are fully with ram chip. I...

Hello, I'm looking for some one has a software for TRS-80 Model II. TRDOS CP/M 2.2 Scripsit and another software. Please let me know. Thanks

Hello, I have an Epson HX20 with memory expansion but I need to know how can I check if all memory are installed, I read the user guide but do not found any command like printmem. Any help please. Thanks...

Hi, The package software of 4-84 work with Kaypro 2x? Help please, Thanks

Hi to all, I have a commodore PET 2001-N, When power on no showing nothing in the screen. Then power off and on again and showing garbage, then power off and on again for several time and boot perfect. So I thing there is a problem with voltage, maybe some capacitor. I think this due when the...

Hi to all, I Have a Model 100 with barcode reader with cassette software, But I need the user manual in order to test it, If anybody have? It's possible to sent in pdf or doc to my email: lramosp@hotmail.com. Thanks for your support.

Hi, I have two kaypro II with the same problem, when power on both drive always is spinning. If removed the flat ribbon cable then do not spin. So I think the floppy controller in the main board are defective. But I would like to know when the computer power on what suppose happen with the...