Search results

Hi all, I just wanted to report a successful repair of a GoldStar MBM-2233 monitor, mfg. date Dec 1984. Click here for the photo album: http://imgur.com/a/27Dws Early symptoms: Randomly the horizontal picture width would twitch a little bit, this went on for some months. Total failure...

Hi all, I have discovered the cause of Sanyo MBC-55x boards that experience disk slow-downs and may eventually lose their ability to access the floppy drives: Part of the circuitry that generates a fake time delay in providing a "head loaded" signal to the floppy controller in response to the...

Hmm, I did a little looking and it seems packet drivers use their own interrupt and don't require DOS - would there be anything stopping me from implementing say, SLIP or a similar serial protocol as a BIOS service?

Hi, I'm getting to the point in writing my Sanyo MBC-55x BIOS that I'd like to create proper interrupt driven buffering serial port support, and I noticed that while the NEC 8251AC chip has a ton of hardware bugs, the intel chip was used on the serial board. The NEC chip is used on the...

If anyone has any accessories for the Sanyo MBC-55x series, I'd likely be interested. Things like CGA/RAM cards, serial UART cards, hard drive, or even interesting software that runs on it... I've already got 2 of the actual machines, so I probably wouldn't be interested in one unless it's...