Search results

WOW This is amazing.. thanks. the 3D printer may get a workout soon

based on the attached image. I measured the center of instruction length 1 to 5 on my panel then I used a image i found online of the actual honeycomb 5*5 block and resized my image to match pixels per mm ( this is as close as I can get ) I also compared other known dimensions of my panel with...

I can only estimate based on dimensions of the panel I will measure it up and see . They look the same size

Thanks. If I had a original honeycomb 3D printing would definitely be a great option. My Dad operated the IBM 1401 at the State Savings Bank of Victoria ( now known as the Commonwealth Bank ) many years ago Apparently it was one of the very few purchased not rented from IBM No idea where it...

Hi Guys I have recently acquired a IBM 1401 control panel ( well it is on its way from USA to Australia ) Thanks to a special person in the USA that helped to make this happen :) I need the honeycomb and lights that are missing from the panel. I see the IBM 1130 uses the same lights and...

DM Sent

Hello What is the deal with this cap. I need a replacement but this one has 3 legs. From the PCB to are just common The markings on it are as follows 180uF 0-50 VDC 672D USA8427H 105 oC The cap looks more like it has corroded than leaked but I would prefer to change it anyway. Can you still...

Wanted to buy IBM 5100 dead of alive ( preferably alive )

Hello I would like to purchase an IBM 1401 Mainframe Computer No I am not joking. Dead or alive. In bits or just bits. Complete or Incomplete. This will be for my own personal collection. It is NOT being used on some movie etc ( so it will be going to a good home )

Adding to an old thread I know. But I recently got myself a Qualstar 1052 off eBay and was not able to get it to read or write and tapes without errors. The tapes I were originally using were only certified at 800CPI so they didn't work on this drive with a minimum read/write of 1600BPI I tried...