Search results

I recently picked up this Intellec 8 (8080) in frankly amazing condition for just 30€. It was purchased and imported to Germany by Siemens in 1974. Due to it still having its 110V volt eprom power supply I believe it to be unused. It even came with the male Current loop plug as well as the 37pin...

I recently scored this on eBay, a Vector Graphics Board for the ADM-3a made by Digital Engineering. It’s compatible with Tektronix Plot 10. The manual can luckily be found on Bitsavers (http://www.bitsavers.org/pdf/digitalEngineering/RG-512_Users_Man_1980.pdf), however mine might be missing ROM...

I recently picked up this non working ADM-3a with severe cataract. Unfortunately the CRT glue has leaked onto the board and caused quite severe corrosion, the tension Band is rusted through as well. The goal here is a full restoration, i‘ll post as i go on.

Now this is a lot newer compared to what I collect usually but I couldn’t resist pulling it out of recycling. There is not mutch information about this model on the internet. It’s not in the best of conditions but I’m not complaining. I just took a look inside the bottom case, it seems to be a...

I’ve recently picked up an Intellec 8, however, unfortunate, it’s missing the key for powering up. Could someone provide me with a good picture of both sides of the key so I can fabricate a replica? Thanks