Recent content by andromeda92

Probleme resolved for my problem hanging checkit and command dos. i have put another ram and all is ok, all work fine now. for EMS I have to use the winbond drivers and activate EMS in bios except that all the memory is allocated to EMS so it is less interesting. I would only use XMS.

Thank for this information, i will do this.

thank you.

I have installed and configured aha-1542cp on dos 6.22 from my 286. disk is scsi 9.1go, i have partitionned and formated the disk with fdisk but i see only 2.1GB in fat16 ? how do i do for see the rest of disk ? i must create extended partition from fdisk ? (max 5.2go it seem).

i have only 8 chip, 8 socket only, and 4 socket for P21256-08, is limited to 1MB, so, i can't put more dip for upgrade, problem resolved. Thanks

Hi, I have a motherboard that accepts SIPP ram memory or DIP RAM, with the SIPP I have a lot of problems, application that blocks but not with the dip ram. Is it possible to upgrade to 4MB with dip ram? by default I had 1MB with DIP RAM which worked well. 8 DIP 20 pin M5M44256BP 117UAOU 8...

Thanks

Hi, I have this card aha-1542cp on 286 16bit isa. What is the maximum disk size I can use with this card? I have a 9.1gb scsi drive. Thanks.

Thank you for this detailled explanation.

thank you for this information, I have not tested it, I will. I will see this drivers to for winbond. Thank you

No is 286 12mhz

NL80286 12/S 4mb 12.5 MHz

is it possible to configure the memory just with XMS (hymem.sys only), without EMS ? because in checkit the tests pass except High Addr Lines, the computer hang, is what to put imperatively DOS=HIGH in the config.sys? if I put DOS=HIGH, the EMS and High Addr Lines tests failed and when I don't...

What is High Addr Lines on checkit3 on menu memory ?

I found information on a Russian site with the same motherboard and which has the same problem as me, apparently it works well with 1MB, with 4MB or 2B there is a problem of stability and xms and ems memory. Message from a person that has a same motherboard that me: It works fine with installed...