Amcodyne Apaphoe 7110

[Marty]

Hi All;
I have an Amcodyne Araphoe 7110 8" Removable Disk Pack Drive, with NO Power Supply, It has an 8 pin connector on the Back for the Power Connection.. I can Ohm it out, and find Ground and +5, and (I think) --5, but the rest I am unsure of, such as the other possible ++ and or -- voltages, and Does it run on +12 or + 24 volt for the spin up motor ?? I don't want to ruin it by assumming anything..
THANK YOU Marty

 

[Chuck(G)]

Wasn't the Amcodyne drive pretty much a plug-in replacement for the CDC Lark? The power connector sounds familiar.

http://bitsavers.informatik.uni-stu...cs/lark/77711094_9457_Lark_ProdSpec_May82.pdf

 

[Marty]

Hi All;
Chuck, I don't know, If it is, But I will check out the Power Connection and see if it matches..
THANK YOU Marty