spiceminer
Experienced Member
Dear all!
I am trying replicate a setup where a PDP11/23 with DEQNA Network interface booted from a VAX.
OS on VAX side was VMS 5.5, OS on PDP side was RSX-11M.
Unfortunately the VAX is dead and I am currently unsure if the VAXes harddrive is still intact and if the configuration is still usable.
In a few weeks I am again on site to check the drive with another VAX.
Does anybody know how this could be accomplished, what Software is required on VAX side with which configuration?
I only know that LAT and DECNET has been used (but as far as I know, RSX supports Decnet III and VAX / VMS Decnet IV)....
Thanks for your thoughts....
best regards
Stephan
I am trying replicate a setup where a PDP11/23 with DEQNA Network interface booted from a VAX.
OS on VAX side was VMS 5.5, OS on PDP side was RSX-11M.
Unfortunately the VAX is dead and I am currently unsure if the VAXes harddrive is still intact and if the configuration is still usable.
In a few weeks I am again on site to check the drive with another VAX.
Does anybody know how this could be accomplished, what Software is required on VAX side with which configuration?
I only know that LAT and DECNET has been used (but as far as I know, RSX supports Decnet III and VAX / VMS Decnet IV)....
Thanks for your thoughts....
best regards
Stephan