rpiguy2
Experienced Member
I have a CP/M small board computer based on the Z180. It has two UARTs built in: ASCII-0 and ASCII-1.
I use ASCII-0 for the terminal and ASCII-1 for file transfers.
I can transfer files to PC/MAC no problem via ASCII-1, but when I try to transfer files (XMODEM or XMODEM-1) from the MAC/PC to CP/M using PCGET it always generates a FRAME ERROR and fails.
I know the serial port settings are correct because I can send to the PC no problem.
What is causing this? I am using Putty with the file transfer extensions.
CP/M 2.2
***
Related topic, is there anyway to directly write to an 8MB SD Card CP/M partition that I made on a Windows device.
I am trying to fill that said partition with software, but since I cannot get PCGET to work it would be very convenient if I could just plug the SD card into my PC and drag the CP/M files over to it.
I use ASCII-0 for the terminal and ASCII-1 for file transfers.
I can transfer files to PC/MAC no problem via ASCII-1, but when I try to transfer files (XMODEM or XMODEM-1) from the MAC/PC to CP/M using PCGET it always generates a FRAME ERROR and fails.
I know the serial port settings are correct because I can send to the PC no problem.
What is causing this? I am using Putty with the file transfer extensions.
CP/M 2.2
***
Related topic, is there anyway to directly write to an 8MB SD Card CP/M partition that I made on a Windows device.
I am trying to fill that said partition with software, but since I cannot get PCGET to work it would be very convenient if I could just plug the SD card into my PC and drag the CP/M files over to it.