Pentium I/II and Athlon Machines

[PS2it]

I've started to notice that I'm seriously out of room, and if planning on getting anything else, I'd better get rid of the stuff I don't use.
I figured this would be a good start.

I've got a few Gateways, both of which are Athlons, the taller being a Slot A, and the other a Socket A (I think?).
I've also got two PII machines, one IBM, and the other was built by Priority Business Systems.
The last is an OMNI-TECH PI, that is in need of some parts to make a decent machine out of (hard drive, video card).

Each one of these was fully restored and rebuilt (other than the modem in the IBM)

More -

Gateway Slot A
Windows ME
64MB of memory

___________________________________________
Other Gateway
Windows XP? (I didn't install that), BSODed, needs reinstall IIRC.
Missing AGP video card

___________________________________________
IBM E96
Windows 98 SE (not original install)
Pentium II
Has an original Working! Quantum BigFoot drive.
After I restored this machine the PSU exploded . So it'll need a new AT PSU or fuse, however, I know it still works, as I tested it with a different PSU.

___________________________________________
Priority Business Systems PII
No hard drive
Tape drive

___________________________________________
OMNI-TECH PI
166MHz PI
No hard drive, video card, etc (see photo).
The motherboard is really odd and only works with one PSU that I know of (can include one).
'

If you're interested, make me an offer over a PM. I really don't know what to ask, however, I'm not looking for much.

Thanks!
PS2it

 

[PS2it]

I figured I'd update this a bit, I'd like to about $30 + shipping or so per machine (OBO depending on which one). Still have all of them, let me know if any one is interested.

 

[retro-pc_user]

Does the Omni-Tech Pentium I machine have the PS/2 mouse adapter as well? Also, that system's board works with either the AT PSU or ATX PSU (jumper must be set accordingly).

 

[PS2it]

Does the Omni-Tech Pentium I machine have the PS/2 mouse adapter as well?

No, unfortunately, this machine doesn't have a PS/2 mouse port. However, I can put one in there if you need as it does have the header.

Also, that system's board works with either the AT PSU or ATX PSU (jumper must be set accordingly).

I did check that jumper before, and even with it on ATX it will only boot with my Antec PSU (has an extra connector that plugs into the motherboard). However, I haven't tried it with an AT PSU.

Here are a couple extra pictures of the Omni-Tech -