I have a pdp-11/84 with a UC17 in it. I have not used it in some time as it's heavy and my
back complains when I try to lift it. I did not use it at all when I lived in Colorado. Now
that I am in Texas I have it on a furniture dolly to move it around. It boots just fine.
I can even boot BSD 2.11 off of a 1GB SCSI drive connected to the UC17. I can't boot
my SCSI2SD and I am sure this is because it's not properly defined in the FRD. But I
can't seem to access the FRD. I follow the instructions I wrote down and seem to get
the proper status. But the "200G" command just hangs. So far I haven't found anything
to help with this. I have the Emulex manual but nothing in there seems to talk about
how to solve problems (maybe just a flow chart but does not help much). Any ideas?
I have RSTS on the SCSI2SD and the light goes on when I try to boot it.
Tim R.
back complains when I try to lift it. I did not use it at all when I lived in Colorado. Now
that I am in Texas I have it on a furniture dolly to move it around. It boots just fine.
I can even boot BSD 2.11 off of a 1GB SCSI drive connected to the UC17. I can't boot
my SCSI2SD and I am sure this is because it's not properly defined in the FRD. But I
can't seem to access the FRD. I follow the instructions I wrote down and seem to get
the proper status. But the "200G" command just hangs. So far I haven't found anything
to help with this. I have the Emulex manual but nothing in there seems to talk about
how to solve problems (maybe just a flow chart but does not help much). Any ideas?
I have RSTS on the SCSI2SD and the light goes on when I try to boot it.
Tim R.