Wanted: FirePro dual-displayport PCI bracket

[xjas]

This is probably a long-shot, but I know some of you deal in decommissioned business workstations, so...

I'm looking for a full-length PCI slot bracket for an ATI FirePro MV 2260. It has two displayport slots and two screw tabs on the bottom for mounting to the card. Here's the SFF version I have:



These were found in Dell Precision T1500/35/55/7500s and probably lots of others. I think they also came in some HPs and boxed, retail.

I'd also buy a whole card for cheap (~$10) as long as it has the full-size bracket.

 

[GiGaBiTe]

It's too bad the card doesn't have a VGA or DVI port because you could just print one out.

I've had to print out card brackets in situations like this, but the supports that go under the card can't be printed with sufficient strength since they're so thin and snap off easily.

Here's one I printed a couple weeks ago:

 

[Unknown_K]

https://www.ebay.com/itm/ATI-FireMV...phics-Card-Dell-7CJHP-w-2-cables/273205528414

 

[xjas]

Thanks for the replies! I actually made my own bracket in the stupidest way possible (hot glue was involved), and then got a second card with a full-size bracket off CL for ten bucks. So I'm good.

Behold the masterpiece:


@Gigabite: that looks a hell of a lot better than what I came up with. Love the translucent plastic too.