Trying to use a WD8013EBT and XENIX 2.3.4 with TCPIP package, but I was unsure what h/w configuration would be suitable for the network card itself.
This card has really a lot of jumper, and for me not all of them have a self explanatory imprinted labeling.
There is a jumper with a label "W0B" ( see also http://stason.org/TULARC/pc/network-cards/S/STANDARD-MICROSYSTEMS-CORPORATION-Ethernet-WD8013E.html ), it seems to be the databus 8/16 selection.
What databus setting should I use for XENIX ? The card itself has a 16 bit ISA bus and is plugged also in a 16 bit ISA bus. So it's 16 bit for sure (but XENIX doc does only mention a WD8003 with 8 bit bus) ?
I/O base was set to 380h, IRQ to 10. You can enter these two settings also during the TCPIP package setup process.
And I didn't insert a boot ROM, so no other settings should be important I guess.
Any suggestions about configuring this card (with XENIX) are welcome ;-)
This card has really a lot of jumper, and for me not all of them have a self explanatory imprinted labeling.
There is a jumper with a label "W0B" ( see also http://stason.org/TULARC/pc/network-cards/S/STANDARD-MICROSYSTEMS-CORPORATION-Ethernet-WD8013E.html ), it seems to be the databus 8/16 selection.
What databus setting should I use for XENIX ? The card itself has a 16 bit ISA bus and is plugged also in a 16 bit ISA bus. So it's 16 bit for sure (but XENIX doc does only mention a WD8003 with 8 bit bus) ?
I/O base was set to 380h, IRQ to 10. You can enter these two settings also during the TCPIP package setup process.
And I didn't insert a boot ROM, so no other settings should be important I guess.
Any suggestions about configuring this card (with XENIX) are welcome ;-)