Papalapa's latest activity

@Paralel, many thanks for the whole information it's very useful for me. Anyway, this company is located in Argentina, not Europe.

The company is: https://floppyemulator.com/ This is the 34 pin to 26 conductor you would need if it is indeed 1.25mm...

Thank you all for the information, it's clear now. @Paralel, I live in Barcelona so, Europe Which is this company that you talk about?.

What is the width of the connector? If it is ~26.0 mm, it is a 1.00mm pitch 26 position FFC cable. If it is significantly larger than...

These Toshiba T1900 series laptops use an older variety of the flat notebook floppy drive connector, it has a wider pin spacing and...

We need a better picture of the the connector. But does it take a mylar ribbon and is there a lift to release plastic retaining clip...

Hi, I'm a retro-computer collector and actually I'm repairing a Toshiba T1910CS laptop. The computer correctly starts up but floppy...

After two years I'm affraid that I'll have the same problem. I ordered the belt and it will be replaced in a few days. Is there any...

I think that IS IDE, it's just a proprietary connector used by that Conner drive and maybe a couple others from that company. I've seen...

Well, as expected even disconnecting the floppy, the hard disk and the fan the computer refuses to boot. I'll try to repair the power...

I own an Epson L2 laptop that did not boots up. When connected to the mains adapter the DC IN light turns on, but turning the switch to...

Willkommen Dennis, it's hard to be a multitasking man as you... :)

Regarding the schematics the entire community of Toshiba collectors would love to have them I feel we’re not doing enough to get them ...

Bad news for me then... :oops: Anyway I'll do my last attemp before to give me up. Thank you for your advise.

Sorry for the delay, only just saw this! It looks like a fusible resistor on the main battery power input rail, measures 1.27 ohms on...