• Please review our updated Terms and Rules here

Gotek newbe troubles

Did you add a jumper to JC too?

Try this should be bootable 6.22 image file
 

Attachments

  • MS-DOS 6.22 Disk 1 Setup.zip
    932.1 KB · Views: 2
THAT IT. IT BOOTS DOS !!
YYYYYHHHHHHAAAAAAAAA !!

That is what was needed, Just to change one jumper S0 to S1, and add a jumper to JC !!!
WE did it.
Many thanks everyone !!
All my bootable .img files do boot!!!
Very cool. this will help me out with a lot of things.
 
KLund1 said:
THAT IT. IT BOOTS DOS !!
YYYYYHHHHHHAAAAAAAAA !!

That is what was needed, Just to change one jumper S0 to S1, and add a jumper to JC !!!
WE did it.
Many thanks everyone !!
All my bootable .img files do boot!!!
Very cool. this will help me out with a lot of things.
Click to expand...
Thanks for this message, my boot floppy disks also did not start, I tried different FF firmware, it did not help
But thanks to you everything works for me
 
Reading FlashFloppy's documentation helps.

github.com

Home

Floppy drive emulator for Gotek hardware. Contribute to keirf/flashfloppy development by creating an account on GitHub.
github.com github.com

Specifically, the jumper configuration is covered in Initial Setup:

github.com

Initial Setup

Floppy drive emulator for Gotek hardware. Contribute to keirf/flashfloppy development by creating an account on GitHub.
github.com github.com
 
There should be a simple chart somewhere that shows the model/version/revision Gotek, and jumpers for all known computers it can work with. Perhaps a Wiki that can be added/modified as time goes on.

After all this, it was just moving two jumpers to make my unit work between a PC/XT/AT and a Atari ST. But it took about a year for me to find that info.
Just ranting, FYI, etc...
 
KLund1 said:
There should be a simple chart somewhere that shows the model/version/revision Gotek, and jumpers for all known computers it can work with. Perhaps a Wiki that can be added/modified as time goes on.

After all this, it was just moving two jumpers to make my unit work between a PC/XT/AT and a Atari ST. But it took about a year for me to find that info.
Just ranting, FYI, etc...
Click to expand...
As I said, it's right there in the Initial Setup page, in the official wiki.

github.com

Initial Setup

Floppy drive emulator for Gotek hardware. Contribute to keirf/flashfloppy development by creating an account on GitHub.
github.com github.com

As an official wiki already exists, why not take advantage of it?
 
You must log in or register to reply here.
Back
Top