RetroNinja
Member
- Joined
- Jul 6, 2022
- Messages
- 41
Hello,
Recently I came into ownership of a GVP A2000-030 EC Combo Rev4 board. I cannot get it to run and was hoping for some help. I did find a manual on Amiga Resources CX but the problem is the manual is for rev1 (I guess). This board is rev4. My board has some of the jumpers moved and some are missing. On the board, not all pin1 are oriented the same. To determine pin1 (so I can figure out the jumper position) I looked at the back of the card and guessed that anything with a square solder point is pin 1> check photos to see what I mean. What I'm hoping to get from here is
Recently I came into ownership of a GVP A2000-030 EC Combo Rev4 board. I cannot get it to run and was hoping for some help. I did find a manual on Amiga Resources CX but the problem is the manual is for rev1 (I guess). This board is rev4. My board has some of the jumpers moved and some are missing. On the board, not all pin1 are oriented the same. To determine pin1 (so I can figure out the jumper position) I looked at the back of the card and guessed that anything with a square solder point is pin 1> check photos to see what I mean. What I'm hoping to get from here is
- a manual for rev4
- opinions on the best placement of jumpers
- someone using this board, listing where their jumpers are placed